Features
- Stainless Steel J-Bracket fixing to mount to wall or ceiling
- 2mm or 3mm acrylic mirror face
- Vinyl celuka back
- Vinyl extrusion
- Wall Mounting screws Not included
- Pole mounting kit available
Suitable Uses
- Swimming Pool Observation
- Chemical Environments
- Coastal Areas
Specifications
International Product Codes
| Product Code | Size Diameter | View Distance | Mirror Face | Mirror Back | Bracket Length |
|---|---|---|---|---|---|
| 18260S | 600mm | Up to 38m | 2mm Acrylic | 10mm Vinyl | 335mm |
| 18276S | 760mm | Up to 46m | 2mm Acrylic | 10mm Vinyl | 335mm |
| 18290S | 900mm | Up to 55m | 3mm Acrylic | 10mm Vinyl | 335mm |
Download PDF Information Guide View
Usage Guides
Positioning
Installation Guide
Outdoor Pool Observation Mirror Installation Guide:
-
Decide the appropriate place to site the mirror to give maximum vision.
-
Fix J-Bracket to wall, ceiling or pillar using suitable fixing hardware (ie: screws, bolts). Allowing enough room to get the mirror on to the J-Bracket.
-
Remove the Adaptor from the J-Bracket.
-
Thread Adaptor into the back of the mirror.
-
Make sure the ventialtion hole is at the bottom, to allow moisture to drain.
-
Peel protective film off around the immediate edge of the mirror.
-
Slide the adaptor and mirror over the J-Bracket and adjust mirror to the desired position.
-
Tighten the locking bolt on the adaptor securely.
-
Totally remove protective film from the mirror face.
Installation:
Optional U-Bolts:
Angle and Position:
Download PDF Installation Guide View
Cleaning Guide
Acrylic Mirror Cleaning Guide:
General Cleaning:
DuraVisionTM recommend cleanning their acrylic mirror faces with soap and water and then with a clean, soft, lint free, damp cloth. Use a non-abrasive polish, such as Johnson’s Pledge or Mr Sheen for a clear bright reflection.
Saturate a clean soft cloth with polish, then spray the mirror face with polish. Wipe the wetted cloth over the mirror surface. With a another clean dry cloth buff the mirror face until it is clear of polish.
DO NOT USE:
- abrasives
- acids
- solvents such as petrol and laquer thinners
Graffiti Removal:
Any graffiti should be removed from the mirror face as soon as possible and preferably within 24 hours. To remove graffiti, use a non-abrasive substance such as De-Solv-it Stain Remover. Not all graffiti cleaning agents are suitable. Failure to use an approved cleaning agent may damage the mirror surface.
Scratches:
To remove scratches or repair blemishes on acrylic mirror faces only, use the following products:
- For cleaning use NOVUS plastic polish #1
- For fine scratches use NOVUS plastic polish #2
- For badly scratched surfaces use NOVIS plastic polish #3 followed by #2 and #1.
